Printing Area - Epson TM-L90 Developer's Manual

Confidential

Printing Area

Thermal Paper
Note:
The printable area may be out of alignment by 2 mm {0.08"} maximum (left or right), due to the paper
position or tolerance of parts. Therefore, the print area must be set in the range of more than 2 mm from
the edges of the paper. To make the margin for both sides safely, it is recommended to set a margin of 2.6
mm {0.1"} or more, as shown in figure above.
Paper Width and Printable Area
Paper width (mm)
Printable area (mm)
Left margin (mm)
Right margin (mm)
Positioning dot number
Total number of dots
Numeric values used above table are center values in designing. Only paper width is for nominal dimension. The
values in parentheses are the maximum value for the paper tolerance.
1-20 Product Overview
Printable Area (For Thermal Paper)
(80) (70)
72 64
2.65 2.65
4.85 2.85
1 576 1 512
576 512
(65) (60) (58)
59 54 52
2.65 2.65 2.65
2.85 2.85 2.85
1 472 1 432 1 416
472 432 416
(50) (45) (38)
44 39 32
2.65 2.65 2.65
2.85 2.85 2.85
1 352 1 312 1 256
352 312 256
Rev. A