Epson TM-L90 Developer's Manual page 45

Confidential
Customized value
Item
Selection of the User NV memory
capacity
Selecton of the NV graphics memory
capacity
Selection of the paper width
Selection of the print control
Selection of the print density
Selection of the print color
Selection of the print speed
Note:
The maximum print speed is given only in a one-part energizing mode. However, if the print duty is high
even through the one-part energizing mode is selected, it may be changed to two-part energizing mode
automatically.
Four-part energizing mode can reduce power consumption.
The print width can be set for 43 kinds with 1 mm pitch in the range from 38 mm to 80 mm. However, it
cannot be set in the range from 71 mm to 79 mm.
Serial transmission conditions
Item
Baud rate
Parity
Flow control
Data length
Rev. A
Value
1 KB 64 KB
128 KB 192 KB
None 64 KB
128 KB 192 KB
256 KB 320 KB
384 KB
38 mm, 39 mm, ..... 79 mm, 80 mm (43 kinds in increment of 1
mm)
One-part energizing
Two-part energizing
Three-part energizing
Four-part energizing
x 0.7 x 0.75
x 0.8 x 0.85
x 0.9 x 0.95
x 1.0 x 1.05
x 1.1 x 1.15
x 1.2 x 1.25
x 1.3 x 1.35
x 1.4
Single color
Two colors
Print speed level 1 (max. 26 mm/s)
Print speed level 2 Print speed level 3
Print speed level 4 Print speed level 5
Print speed level 6 (max. 120mm/s)
Print speed level 7 Print speed level 8
Print speed level 9 (max. 150 mm/s)
Selection
115200 bps 9600 bps
57600 bps 4800 bps
38400 bps 2400 bps
19200 bps
None/ Odd/ Even
DTR/DSR control
XON/XOFF control
7-bit/8-bit
TM-L90 Developer's Guide
Setup 2-11