Epson TM-L90 Developer's Manual page 98

Confidential
Connector circuit
A
B
Note:
The following restrictions apply to the drawer kick connector.
Be sure to use resistance of 24 Ω or greater for the drawer solenoid. If less than 24 Ω , overcurrent can
•
develop that will burn out the solenoid.
• Use shielded cable for the drawer connector cable.
• Two drives cannot be operated at the same time.
• Do not operate the drawer on a continuous basis.
• Make sure to use the printer power supply (4 pin connector) as the drawer power supply.
• Do not connect a standard telephone line to the drawer kick connector.
Rev. A
Drawer kick connector
F. G
P-GND
+24V
P-GND
Printer Side
1
2
3
4
5
6
User side (drawer side)
TM-L90 Developer's Guide
Shielded type
Drawer kick solenoid
OPEN/CLOSE
SW
Interface And Connectors A-13