Table of Contents
Advertisement
Chapter 6
Notices for Replacement of the TM-U210/TM-U300
TM-U220 is designed to smoothly replace the TM-U210/TM-U300. This section gives answers to
your questions.
6.1 For Replacement of the TM-U210
When you replace TM-U210 with the TM-U220, you have to set the memory switch [MemSW8-5:
OFF (default)] and [MemSW 8-8: OFF (default)] to get the same status provided by the TM-
U210. See "Provided statuses" (page 6-5) for details.
6.1.1 About printing format compatibility
The TM-U220 can provide almost the same printing result as the TM-U210. This section
describes the reasons, which are printing area compatibility, character compatibility, and top
margin compatibility (cutting position.)
6.1.1.1 Printing area
The TM-U220 has almost the same printing area as TM-U210 as shown in the following table
and figures.Therefore, the TM-U220 can print same contents as the TM-U210 without adjusting
any original control sources.
Printing areaItem
Print width
Left margin
Right margin
76 mm
Printable area
5.9 mm
Rev. H
TM-U210 (Type A,B,D)
63.34mm
(200dots, 400 position)
(5.9mm)
(6.76mm)
63.34 mm
6.76 mm
TM-U210
Printing area and margins
TM-U220 (Type A,B, D)
(when 76mm paper using)
63.34mm
(200dots,400position)
6.8mm
5.8mm
6.8 mm
TM-U220 (When using 76mm roll paper)
Notices for Replacement of the TM-U210/TM-U300 6-1
TM-U220 Technical Reference Guide
76 mm
63.34 mm
Printable area
5.8 mm
These values are reference values
Advertisement
Table of Contents
