Tm Setup Items (Summary) - Epson TM-L90 Developer's Manual

Confidential

TM Setup Items (Summary)

Items of TM setup are shown below, refer to below table about setting items and adequate
switches.
Item
Autocutter Setting cut type
Paper width When change paper width
Paper roll near- Adjusting detector of near
end adjusting end paper roll
Enable/disable P ower switch can be
power switch (*) invalidated.
Select for serial Serial communication
communication settings can be made
condition either by DIP switch or
memory switch. If DIP
switch 2 is on, the DIP
switch setting is read; if DIP
switch 2 is off, the memory
switch setting is read.
When the printer is turned
on, either setting should be
read can be selected.
Set for serial Handshake, Bit length,
communication presence of Parity check,
condition Parity select, Baud rate
select.
Operation when Use only when you must
starting shift to the memory
rewriting mode. It is not
used normally.
Send power on Transmit data of 3 bytes
notification when it is on.
Select receive Select capacity of receive
buffer capacity(*) buffer large or small.
Conditions for Select condition for Busy.
Busy Status (*)
Data processing Select print "?" or ignored.
when reception
error occurs
2-8 Setup
Description Mechanic
(See page
2-12 for full/
partial cut)
(See page
2-14)
(See page
1-6)
Setting method
DiP switch Memory switch
Yes -- Memory switch
(Msw 2-2) for
Yes -- Memory switch
(Customized
Yes --
-- DIP switch
1-1
-- DIP switch
1-2
-- DIP Memory switch
switches (S erial
1-3 to 1-8 communication )
-- DIP switch
2
-- -- Memory switch
-- -- Memory switch
-- -- Memory switch
-- -- Memory switch
Setting Memory
switch
command GS ( E, or
panel operation
disability
command GS ( E
value)
--
--
--
command GS ( E, or
panel operation
--
command GS ( E
(Msw 1-1)
command GS ( E, or
(Msw 1-2) panel operation
command GS ( E, or
(Msw 1-3) panel operation
command GS ( E, or
(Msw 1-4) panel operation
--
--
--
--
Rev. A