Connecting Power Supply Unit - Epson TM-L90 Developer's Manual

Confidential
Connecting Power Supply Unit (PS-170,PS-180)
Be sure to use the EPSON PS-170, PS-180 or the equivalent product as the power supply unit.
WARNING:
Always use the EPSON PS-170, PS-180 or equivalent product as the power supply unit.
Using a nonstandard power supply can result in shocks and even fire.
Should a fault ever occur in the EPSON PS-170, PS-180 or equivalent product,
immediately turn off the power to the printer and remove the power supply cable from
the wall socket.
CAUTION:
Be sure to remove the power supply cable from the wall socket whenever connecting
or disconnecting the power supply unit to the printer. Failure to do so may result in
damage to the power supply unit or the printer.
Be sure to confirm that the wall socket power supply satisfies the rated voltage
requirements of the power supply unit. Never insert the power supply cable plug into a
socket that does not meet the rated voltage requirements of the power supply unit.
Doing so may result in damage to both the power supply unit and the printer.
1. Confirm that the printer's power supply is turned off and the power supply unit's power
cable has been removed from the wall socket.
2. Check the specifications label on the power supply unit to confirm that the wall socket
power supply meets the rated voltage requirements.
3. To place cables, first break off by hand any of the three portions indicated by circles in the
illustration (the other portion is on the right). Then put the cables through the holes and
replace the bottom of the cover.
Rev. A
TM-L90 Developer's Guide
Connection of Cable and Option D-7