Temporarily lowering sensor sensitivity
■
The sensitivity of the sensor can be temporarily lowered.
Turn the engine switch off while the following conditions are met.
1
• The headlight switch is in
• The headlight switch lever is in high beam position.
• Automatic High Beam switch is on.
Turn the engine switch to IGNITION ON mode.
2
Within 30 seconds after
3
position then pushing it to the high beam position quickly 10 times, then leave the
lever in high beam position.
If the sensitivity is changed, the Automatic High Beam indicator is turn on and off
4
three times.
Automatic High Beam (headlights) may turn on even the vehicle is stopped.
ES350_OM_OM33B64U_(U)
4-3. Operating the lights and wipers
or
.
, repeat pulling the headlight switch lever to the original
2
I n f o r ma t i o n P r o v i d e d b y :
167
4