Table of Contents
Advertisement
3. S
ETUP
AC Power
Mounting
Orientation
Rigging
Mounting Diagram
D-Fi™ Stream 6 User Manual Rev. 1
This product has an auto-ranging power supply and it can work with an input voltage of
100 to 240 VAC, 50/60 Hz.
To determine the power requirements for this product (power outlet and wiring), use the
current value listed on the label affixed to the product's back panel, or refer to the
product's specifications chart. The listed current rating indicates the product's average
current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse),
making sure that it has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Before mounting this product, read and follow the
The D-Fi™ Stream 6 may be mounted in any position; however, make sure adequate
ventilation is provided around the product.
Before deciding on a location for this product, always make sure that it will be easy to
access the unit for maintenance and programming purposes.
Make sure that the structure onto which you are mounting this product can support its
weight. See the
Technical Specifications
When mounting this product overhead, always use a safety cable. Mount the product
securely to a rigging point, whether an elevated platform or a truss.
When rigging this product onto a truss, you should use a mounting clamp of appropriate
weight capacity.
The product also has two 10 mm mounting holes located on the back and top for easy
truss mounting.
Rack
Mounting
Holes
Safety
Notes.
for weight information.
Mounting Holes
Page 7 of 12
Advertisement
Table of Contents
