Table of Contents
Advertisement
Item
DHCPv6 Server
Configuration
DNS Server IPv6 Address
After finishing all the settings here, please click OK to save the configuration.
3
.
1
1
.
3
F
i
r
e
w
a
l
l
S
3
.
1
1
.
3
F
i
r
e
w
a
l
l
S
This page allows users to set firewall rules for IPv6 packets.
Note: Section 3.4 Firewall is configured for IPv4 packets only.
Each item is explained as follows:
Item
Name
Protocol
Source IP
Destination IP
Source Port
Destination Port
Action
Description
Advertisement messages, specified by RFC 2461, to a local
Ethernet LAN periodically and when requested by a node
sending a Router Solicitation message. These messages are
required for IPv6 stateless auto-configuration.
Enable – Check the box to enable RADVD server.
Advertisement Lifetime - The lifetime associated with the
default router in units of seconds. It's used to control the
lifetime of the prefix. The maximum value corresponds to
18.2 hours. A lifetime of 0 indicates that the router is not a
default router and should not appear on the default router
list.
Enable – Check it to enable such setting.
Start IPv6 Address/ End IPv6 Address - Type the start
and end address for IPv6 server.
Primary DNS Server - Type in the primary IP address for
the DNS Server.
Secondary DNS Server - Type in secondary IP address for
the primary DNS Server.
e
t
u
p
e
t
u
p
Description
Display the name of the rule.
Display the protocol (TCP/UDP/ICMPv6) the rule uses.
Display the source IP address of such rule.
Display the destination IP address of such rule.
Display the source port number of such rule.
Display the destination port number of such rule
Display the status (accept or drop) of such rule.
144
VigorFly 210 Series User's Guide
Hide quick links:
Advertisement
Table of Contents
