Draytek VigorFly 210 User Manual page 123

Universal Repeater
Antenna
Tx Power
Channel Width
After finishing all the settings here, please click OK to save the configuration.
VigorFly 210 Series User's Guide
That is, the wireless client must support this feature and
invoke the function, too.
Note: Vigor N61 wireless adapter supports this function.
Therefore, you can use and install it into your PC for
matching with Packet-OVERDRIVE (refer to the following
picture of Vigor N61 wireless utility window, choose
Enable for TxBURST on the tab of Option).
If such mode is enabled, the access point can act as a
wireless repeater; it can be Station and AP at the same time.
It can use Station function to connect to a Root AP and use
AP function to service all wireless stations within its
coverage.
Check this box to enable the function. Besides, it will be
displayed on the Wireless LAN for you to access for
detailed configuration.
Open Wireless LAN>>Universal Repeater. Please refer to
the corresponding section for detailed information.
Specify the type of the antenna used for your router.
Set the power percentage for transmission signal of access
point. The greater the value is, the higher intensity of the
signal will be.
Auto 20/40 MHZ - The router will use 20Mhz or 40Mhz
for data transmission and receiving according to the station
capability. Such channel can increase the performance for
data transmission.
20 MHZ- the router will use 20Mhz for data transmitting
and receiving between the AP and the stations.
115