Board - Sony SRW-5000 Maintenance Manual

5-30-15. LED-386 Board
Replacement
1. Turn the power off and disconnect the power
cord.
2. Remove the front panel assembly.
(Refer to Section 1-3-3.)
3. Disconnect the harness from the connector
CN1 on the LED-386 board.
4. Remove the two screws and remove the
LED-386 board.
5. Perform the installation in the reverse order
from steps 2 to 4.
Steps after Replacement
6. Confirm that the corresponding format lamp
indicator will light up when the cassette tape
recorded in each format is inserted.
5-30-16. SWC-43 Board
Replacement
1. Turn the power off and disconnect the power
cord.
2. Remove the front panel assembly.
(Refer to Section 1-3-3.)
3. Disconnect the harness from the connector
CN1 on the LED-386 board.
4. Remove the two screws and remove the
SWC-43 board.
5. Disconnect the harness from the connector
CN1 on the SWC-43 board.
6. Perform the installation in the reverse order
from steps 2 to 5.
Steps after Replacement
7. Check that the switches and indicators
function normally.
SRW-5000/5500
CN1
BVTT3 x 6
Remove the LED-386 Board
CN1
CN1
BVTT3 x 6
SWC-43 board
Remove the SWC-43 Board
LED-386 board
LED-386 board
5-121