Sony SRW-5000 Maintenance Manual page 250

Removal
1. Removing the Reel Table Assembly
(1) Press down the claws of reel table assembly
and loosen the two set screws.
(2) Remove the reel table assembly.
n
When the reel table assembly is removed, a
poly-slider washer for reel table height
adjustment may adhere to it.
Be sure to check if the poly-slider washer
exists or not before returning it to the reel
motor shaft.
If the poly-slider washer is lost, the height of
the reel table can not be met the specification
and that will cause the abnormal tape run-
ning.
Installation
2. Attaching the Reel Table Assembly
(1) Clean the perimeter of the reel table assembly
with a cleaning cloth moistened with cleaning
fluid.
(2) Confirm that the number of the poly-slider
washers inserted in the reel motor shaft is the
same as in the removal.
n
When the poly-slider washer is lost, insert the
following number of poly-slider washers into
the reel motor shaft.
S-reel: Poly-slider washer (t = 0.13 mm) x1
Sony part No. : 3-701-441-01
Poly-slider washer (t = 0.25 mm) x1
Sony part No. : 3-701-441-11
T-reel: Poly-slider washer (t = 0.13 mm) x1
Sony part No. : 3-701-441-01
(3) Release the reel brake in the arrow direction
and pass the reel table assembly through the
reel motor shaft.
(4) Press down the claws and tighten the two set
screws.
Tightening torque: 58.8 x 10
{6.0 kgf.cm}
Adjustment after Replacement
3. Confirming the Tape Running
Refer to Section 6-12.
5-44
S reel brake
_2
N.m
Craw
Set Screws of the Reel Table Assembly
S reel table assembly
Cleaning
Remove/Attach the Reel Table Assembly
Set screws
T reel table assembly
Cleaning
T reel brake
SRW-5000/5500