Sony HDW-F500 Maintenance Manual page 95

ERROR-01 REEL TROUBLE-1
Description: Tape slacking is detected during threading or unthreading.
Sub messages and detecting conditions:
(1) Slack detected (T-REEL/THREADING)
When the relation between T reel FG and threading FG is out of the specification during
threading or unthreading after tape winding diameter measurement
(2) No FG Detected (S/T REEL)
When T reel FG is not detected for a certain period of time while the S reel is stopping
during threading or unthreading before tape winding diameter measurement
completed.
Possible causes:
. T reel motor defective.
. T reel motor drive circuit (DR-307 board) malfunction.
. T reel FG waveformshaping circuit (DR-307 board) malfunction.
. T reel brake defective.
. T reel brake solenoid drive circuit (DR-307 board) malfunction.
. Servo adjustment is faulty for T reel.
. Height adjustment is faulty for T reel.
. Cassette compartment defective or installation of it is faulty.
(The reel stopped rotating because of the rising of the cassette tape from its reference
position.)
. Clearance adjustment is faulty for T reel FG detection block.
. Disconnection of harness.
Protecting operations:
The protection mode is selected, and threading or unthreading operations are stopped.
n
Be ensure to remove the cassette tape with your hand, after turning the power OFF.
If the power is turned ON again without removing the cassette tape, the tape may be dam-
aged.
(Refer to "2-12. Removing the Cassette Tape When Tape Slack Occurs".)
(*1): The state in which tape winding diameter measurement is completed meens REMAIN TIME is
displayed on the control panel.
However, REMAIN TIME is not displayed even if tape winding diameter measurement is complet-
ed during threading and unthreading.
HDW-F500E MMP1
3-2. Error Messages
(*1) is completed.
(*1) is
3-3