Sony HDW-F500 Maintenance Manual page 25

Rack Mounting Procedure
(Removal of feet)
(1) Place the right side panel of the unit facing down.
n
As the lower handle will hang down, hold it with your
hand so that it does not hang down.
(2) Remove the four screws, and remove the feet from the
bottom of the unit.
(3) Place the unit horizontally again.
Foot
Foot
n
Keep the screws removed and feet removed properly.
If removing the unit from the rack and using, be sure to
attach the feet.
Tightening torque: 9.8 N . cm {10 kgf . cm}
HDW-F500E MMP1
PS4 x 14
PS4 x 14
<Attachment of inner rails>
(4) Pull out the inner rails from the two intermediate rails.
(5) While pressing the stopper of the inner rail in the
direction of arrow A shown in the figure, pull out the
inner rail in the direction of arrow B.
Intermediate rail
Inner rail
Stopper
B
(6) Remove the ten screws shown in the figure from both
the left and right sides of the unit.
(7) Attach the two inner rails to both the left and right
sides of the unit using the screws removed in the
procedure (6).
Tightening torque: 1.2 N . m {12.2 kgf . cm}
n
Be sure to attach the inner rail using the B4 x 6
screws.
Using other screws may cause problems in the opera-
tions of the unit.
Inner rail
B4 x 6
1-6. Installation of HDW-F500
Outer rail
A
Inner rail
B4 x 6
1-15