Removing/Installing The Connector Panel Assembly - Sony HDW-F500 Maintenance Manual

Lower Control Panel
n
Be sure to remove the memory card before beginning
removal/installation.
1. Remove the control panel assembly from the unit.
(Refer to "2-4. Removing/Installing the Lower Control
Panel Assembly".)
2. Remove the seven screws at the top and bottom.
3. Disconnect the connector (CN1) from the SW-749
board.
4. Remove the lower control panel in the arrow direction.
BVTT3 x 6
BVTT3 x 6
To install, perform the reverse order of this procedure.
HDW-F500E MMP1
CN1
Lower control panel
2-5-3. Removing/Installing the Connector
Panel Assembly
c
To prevent electrical hazards, be sure to turn off the
POWER switch and unplug the power cord before starting
the removal/installation.
1. Remove the six screws shown " " marks on the
connector panel.
Connector panel
2. Open forward the connector panel, but do not pull the
harnesses.
To install, perform the reverse order of this procedure.
2-5. Removing/Installing Cabinet
BVTT3 x 6
BVTT3 x 6
BVTT3 x 6
Connector panel
2-5