Table of Contents
Advertisement
SP2060
I
UPDATING PROGRAM, BOOT AND COMPONENT DATA
For updating the program, it is recommended to use the DME Designer (version 2.0 or later).
Here, the updating procedures using SP2060 data package are explained.
1.
Preparation
1-1.
Required items
• SP2060
• LAN cross cable
• Personal Computer: DOS/V machine (P-200MHz or faster, Windows2000/XP, Ethernet port) : 1 pc
1-2.
Personal Computer Setting
Refer to "Test program 1-2. Personal Computer Setting" on page 36 for information on setting the personal computer.
1-3.
Connection
Connect the NETWORK connector of the SP2060 to the LAN connector of the personal computer with the LAN cross cable.
2.
Updating the program and boot
2-1.
Activating the SP2060
While pressing the [SEL5] and [SEL6] keys, turn on the power to the SP2060.
Keep pressing the [SEL5] and [SEL6] keys until "Copyright 2006 YAMAHA" disappears from the display of SP2060.
2-2.
Activating the update software
The update software for program and the update software for boot are different.
To update the program, click on "update.exe" of C:￥TOOLS_SP2060￥tools￥update￥prog.
To update the boot, click on "update.exe" of C:￥TOOLS_SP2060￥tools￥update￥boot.
Note
It is impossible to update the boot with the DME Designer (version 2.0 or later).
2-3.
Setting the parameters
When update software is activated, the setting and executing screen is displayed. (Fig. 1 [Setting and executing screen])
Set the parameters according to the following parameters.
Output Port
Input Port
target ID
Firmware
Download File
60
: ZONE1
: ZONE1
: 2
: Select either PROGRAM or BOOT for which you wish to update.
: Select either C:￥TOOLS_SP2060￥prog￥SP2060_PROG.BIN or C:￥TOOLS_SP2060￥prog
￥SP2060_BOOT.BIN for which you wish to update.
Update
PROGRAM
C:￥TOOLS_SP2060￥prog￥SP2060_PROG.BIN
BOOT
C:￥TOOLS_SP2060￥prog￥SP2060_BOOT.BIN
[SEL5]
Download File
: 1 pc
[POWER]
[SEL6]
Advertisement
Table of Contents
