Target Past Track; Setting Target Past Track Function - JRC JMA-7710-6 Instruction Manual

5.10

Target Past Track

Target past track function cannot be used in the radar mode.
Use it in the composite mode (a plotter option is required.)
Setting the composite mode
When pressing the
Procedures
mode, composite mode (R+P), and plotter mode (the NDB-33 plotter option
is provided).
The composite mode is selected.
Attention
The past track of a target which is tracked by the ATA is stored and displayed.
The tracking target with its target number (Other ship's track number) is set so that target past track
can be displayed.
5.10.1

Setting Target Past Track Function

Attention
Setting this function to ON stores and displays up to 10 target past tracks.
Setting it to OFF does not store and display target past track.
If target past track is not erased, this function holds the storage of target past track even while it is set
to OFF.
1. Press the
Procedures
2. Press the
3. Press the
4. Press the
5. Press the
Exit 6. Press the
MAP
key, the mode sequentially changes into the radar
SUB
key to open the SUB MENU.
MENU
7
key to open the ATA TRACK menu.
1
key to select "TRACK FUNCTION".
1
key to select "OFF" or "ON".
ENT
key.
SUB
key to close the ATA TRACK menu.
MENU
5 – 31