Glass Replacement - Quadra-Fire CB1200M-MBK Installation And Operation Maintenance

CB 1200 Pellet Stove
H. Glass Replacement
WARNING
• Glass is 5mm thick high temperature heat-
resistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury.
• Remove door from appliance and place face down on
a protected surface to avoid scratching the door.
• Remove all door rope.
1. Replacing Center Glass
NOTE: DO NOT LET Air Wash Spacers fall down from
top frame when removing and replacing center
glass.
a. Be sure the appliance is allowed to cool, has been
unplugged and the exhaust blower is off.
b. Using a nut driver remove the (5) bottom nuts and
remove the bottom glass frame. Figure 36.2.
c. Slightly bend up and out of the way the 2 center posts
and slide the glass out the bottom.
d. Slide new glass in, reposition the 2 center posts and
re-install bottom glass frame.
e. Re-rope the door.
2. Replacing Side Glass
NOTE:
When removing the side glass with the door
latch, you must remove the door latch fi rst
before removing the side frame. Use a pow-
ered Phillips head screw driver to remove the
4 screws.
a. Be sure the appliance is allowed to cool, has been
unplugged and the exhaust blower is off.
b. Remove side glass frame.
c. Loosen the top and bottom frame and slightly bend
up and out of the way.
d. Slide glass out the side and slide new glass in.
e. Re-install the side glass frame and tighten the top
and bottom frames.
f. Re-install the door latch, if applicable, and re-rope
the door.
Page 36
Top & Bottom Frame
Center Posts
Figure 36.1
Remove Door Latch First
and then Side Frame
Figure 36.2
• Do NOT operate with glass cracked, broken or scratched.
7014-179K
Door Latch
Glass
Door Frame
shown with no
Glass or Glass
Frames
Remove 5 nuts from Bottom Frame
WARNING
Handle glass with care.
• Inspect the gasket to ensure it is
undamaged.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass
assembly removed.
R
Side
Frame
May 6, 2015