Service Parts Replacement; Glass Replacement - Door Assembly; Igniter Replacement - Quadra-Fire CASTILE-MBK-B Owner's Manual

Castile-b pellet appliance
Hide thumbs Also See for CASTILE-MBK-B:
Table of Contents

Advertisement

5

Service Parts Replacement

A. Glass Replacement - Door Assembly
(Replace with 5mm ceramic glass only)
1. Open the face and remove door from the appliance by
lifting door off of hinge pin and lay on a flat surface face
down.
2. Using a screwdriver, tap the bottom of the rope retainer
rod to push it up out of the hole. The top end of the rod
will slide up. Swing the rod toward you from the bottom
and remove the rod. Repeat for other side.
3. Remove old glass and replace with new glass.
4. Slide the retainer rod into the top hole first, and then
line up the bottom crimped end with the hole in the
door. The crimped end must be parallel with the glass
in order to insert it into place. Figure 19.1.
Rope Retainer
Glass
Figure 19.1
WARNING
• Glass is 5mm thick high temperature heat-re-
sistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury.
November 27, 2017
Rods
Slide this end
in first
Crimped end at
the bottom
Crimped end
must be
parallel with
the glass
B. Igniter Replacement
1. Shut down the appliance by turning down the thermostat
and let the appliance completely cool down. After the
appliance has cooled down, unplug it and remove the
ash drawer.
2. The wire leads to the igniter are connected to the wire
harness with 1/4 inch male / female spade connectors.
Disconnect the spade connections and remove the
igniter from the chamber. Loosen thumb screw and
slide igniter out.
3. Install new igniter into the chamber and tighten thumb
screw. Re-connect the wires to the 2 leads with the
spade connectors.
4. Double check that the igniter wires are clear of any
movement, i.e. ash drawer, fire pot cleaning rod,
cleaning slide plates, etc.
5. Re-install the ash drawer and side panel and re-connect
the power.
Igniter Bracket
Figure 19.2
Shock Risk.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
7021-155F
CASTILE FREESTANDING
Igniter
Thumb Screw
CAUTION
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Castile-csb-bCastile-pmh-bCastile-cwl-b

Table of Contents