Baffl E Removal; Igniter Replacement - Quadra-Fire CB1200M-MBK Installation And Operation Maintenance

R
2. Exhaust Blower Replacement
Remove existing blower:
a. Use proper shut down procedures to shut down the appli-
ance and let it completely cool and then unplug it.
b. Use an 11/32" wrench or nut driver to loosen and remove
the (6) nuts holding motor mount plate to the blower hous-
ing on your stove.
c. Remove washer from beneath the terminal ring on the
grounding wire.
d. Pull motor/mounting plate from blower housing.
e. Scrape off old gasketing material from blower housing.
Install new blower:
f. The blower and blower housing is shipped as a unit. It is
necessary to separate them at this point if you are using
the existing blower housing already installed on the appli-
ance:
g. Follow steps 2 and 3 above. Discard or set aside the new
blower housing.
h. Carefully remove gasketing from new housing and set
onto the blower housing.
Re-install blower to blower housing:
i. Install blower on housing ensuring that wiring exits facing
the 8 o'clock position. Place the washer and then the
grounding wire on nearest mounting plate stud.
j. Use nuts removed in step b to secure blower to housing.
k. Re-connect wiring (use jumper wire if necessary). Re-
connect power supply.
F. Baffl e Removal
1. Use proper shut down procedures to shut down the
appliance and let it completely cool down.
2. Open right side panel and then open the door.
3. The 2 baffl es are located at the top inside of fi rebox.
4. Place your hand on the baffl e and slide it up and the
bottom edge will fall down and then you can lift the baffl e
out. Repeat for the other side.
1. Remove Baffl e to Access Heat Exchanger
Tubes and Firebox Exhaust Exits
1. Open the upper right side panel door and then open the
glass door.
2. The 2 baffl es are located at the top inside of fi rebox.
3. Place your hand on the baffl e and slide it up and the
bottom edge will fall down and then you can lift the baffl e
out. Repeat for the other side.
4. Re-install in reverse order.
May 6, 2015
G. Igniter Replacement
1. Use proper shut down procedures to shut down the
appliance and let it completely cool down and then
unplug it and remove the ash drawer.
2. Follow instructions to remove the ash pan found on
page 31. Remove the access plate directly above it
by removing the 2 screws just below the ash catcher.
3. The wire leads to the igniter are connected to the wire
harness with 1/4 inch male / female spade connectors.
These wires will pull forward approximately 4 to 5 inches
(102mm to 127mm). Disconnect the spade connections
and remove the igniter from the chamber. Loosen the
thumb screw and slide igniter out.
4. Install new igniter into the chamber and tighten the
thumb screw. Re-connect the wires to the 2 leads with
the spade connectors.
5. Remove right side panel and pull wire leads back toward
the rear of the appliance to take-up the 4 to 5 inches
(102mm to 107mm) previously pulled out. This will
keep the wires out of the way of the ash drawer. Double
check that the igniter wires are clear of any movement,
i.e. ash drawer, fi repot cleaning rod, etc.
6. Re-install the ash drawer and side panel and re-connect
the power.
Igniter Bracket
Thumb Screw
Figure 35.1
7014-179K
CB 1200 Pellet Stove
Igniter
Page 35