Igniter Replacement; Baffle & Brick Removal - Quadra-Fire SANTAFE-B1 Owner's Manual

R
C. Blower Replacement
1. Convection Blower Replacement
a. Turn down the thermostat, let appliance completely cool
and then unplug appliance before servicing.
b. The Convection Blower is located on the floor at the
rear of the appliance.
c. Remove the right lower side curtain by pulling out on
the front and swing it to the back and then off of the
appliance. Figure 32.1.
d. Cut the tie wire holding the wires togehter and then dis-
connect the yellow and purple wires.
e. Re-install in reverse order.
f. Attach new tie wire to hold wires together.
right side curtain
Figure 32.1
Convection
Blower
Figure 32.2
Page 32
Remove lower
Exhaust
Blower
Pull blower up of the locating
pins and pull towards you.
2. Exhaust Blower Replacement
a. Turn down the thermostat, let appliance completely cool
and then unplug appliance before servicing.
b. Remove both lower side curtains. Figure 32.1.
c. Remove the lower rear screen and lay flat, leaving all
wires still attached.
d. Remove the upper rear screen from the appliance by
removing 2 screws at the top, 1 in the center and 2 screws
on the sides at the top. Leave both upper side curtains still
hinged in place to the rear screen. Figure 32.3.
e. Remove the 2 screws holding the vacuum switch in place.
Disconnect vacuum hose and blue and white wires from
the vacuum switch.
f. Remove the 2 screws holding the junction box in place.
e. Disconnect the white and blue wires from the exhaust
blower.
f. There is a removable plate on the exhaust blower. Using
a 1/4" nutdriver loosen the 6 screws in the keyhole shaped
holes and rotate the plate. Figure 32.4
g. Remove the exhaust blower and gasket.
i. Re-install in reverse order.
Remove 2 screws, 1 on each side
Vacuum Switch
Tabs at bottom of upper rear screen
Figure 32.3
Figure 32.4
7001-142C
Santa Fe Pellet Stove
Junction Box
Screws
Screws
November 2, 2005