General Settings; Streaming Settings - D-Link DCS-6220G User Manual

DCS-660G User's Manual
Configuration > Advanced > Network (continued)
Reset IP Address at next boot
Once the DCS-6620G is configured, this box should be unchecked at all times. If the box has been checked
and the connection is lost, run Installation Wizard to find the camera's IP address.

General Settings

Secondary DNS:
HTTP Settings

Streaming Settings

UDP Video channel port:
UDP Audio channel port:
D-Link Systems, Inc.
IP address:
Necessary for network identification.
Subnet mask:
Used to determine if the destination is in the same subnet. The
default value is "55.55.55.0."
Default router: The router used to forward frames to destinations in a different subnet.
Invalid router settings may cause the failure of transmissions to a
different subnet.
Primary domain name server that translates names to IP addresses.
Primary DNS:
Secondary domain name server to backup the primary one.
Can be set to other than the default port 80. When the
HTTP Port:
administrator changes the HTTP port of the DCS-6620G (which
has an IP address of 192.168.0.120) from 80 to 8080, users
must type http://192.168.0.100:8080 in the Web browser bar.
Can be set to other than the default port 5002 to correspond with the
port opened by the firewall
Can be set to other than the default port 5003 to correspond with the
port opened by the firewall.
Using the DCS-660G with an Internet Browser
39