Servicing The Engine Oil - Toro Workman MD Operator's Manual

3. Insert the air-filter element into air-filter housing
(Figure 29).
Note: Ensure that the filter is sealed properly by
applying pressure to the outer rim of the filter when
installing it. Do not press on the flexible center of the
filter.
4. Align the air-cleaner cover with the air-cleaner housing
(Figure 29).
5. Secure the cover to the housing with the latches
29).
6. Lower the cargo box; refer to
(page 17).
(Figure
Lowering the Cargo Box

Servicing the Engine Oil

Service Interval: After the first 25 hours
Every 100 hours (Change the oil twice as often during
special operating conditions; refer to Maintaining the
Vehicle under Special Operating Conditions.)
Note: Change the oil more frequently when operating
conditions are extremely dusty or sandy.
Note: Dispose of the used engine oil and oil filter at a
certified recycling center.
Changing the Oil (Models 07266TC and
07279)
Oil Type: Detergent oil (API service SJ or higher)
Oil Capacity: 1.1 L (1.2 qt)
Viscosity: See the following table.
1. Start the vehicle and let the engine run for a few
minutes.
2. Park the machine on a level surface, set the parking
brake, rotate the On/Off switch to the Off position,
and remove the key.
3. Raise the cargo box and secure it with the prop rod;
refer to Raising the Cargo Box (page
4. Disconnect the positive battery cable; refer to
Disconnecting the Battery (page
5. Align a drain pan with a 1.5 L (1.6 qt) capacity under
the drain plug (Figure
30
Figure 30
17).
35).
31).