Engine Maintenance; Servicing The Air Filter - Toro Workman MD Operator's Manual

Engine Maintenance

Servicing the Air Filter

Service Interval: Every 100 hours Replace the air filter
element sooner if it dirty or damaged.
After the first 200 hours
Note: Service the air cleaner more frequently (every few
hours) if operating conditions are extremely dusty or sandy.
Checking the Air Filter
1. Raise the cargo box and secure it with the prop rod;
refer to Raising the Cargo Box (page
2. Check the air cleaner body for damage which could
possibly cause an air leak. Ensure the cover is sealing
around the air cleaner body
Note: Replace a damaged air cleaner cover or housing.
Figure 28
1. Air-filter assembly
(Models 07266TC and
07279)
2. Back of the machine
17).
(Figure 28 and Figure 29).
3. Air-filter assembly
(Models 07359 and
07359TC)
1. Air-filter housing
2. Air-filter element
3. Release the latches securing the air-filter cover to the
air-filter housing
4. Separate the air-filter cover from the air-filter housing,
and clean the inside of the cover
5. Gently slide the air-filter element out of the filter
housing.
Note: To reduce the amount of dust dislodged, avoid
knocking the filter against the air-filter housing.
6. Inspect the air-filter element.
•
If the air-filter element is clean, install the filter
element, refer to
•
If the air-filter element is damaged, replace the filter
element; refer to
Replacing the Air Filter
1. Remove the air-filter element; refer to .
2. Inspect the new filter for shipping damage.
Note: Check the sealing end of the filter.
Important: Do not install a damaged filter.
3. Install the new air filter; refer to
(page 29).
Installing the Air Filter
Important: To prevent engine damage, always operate
the engine with the complete air cleaner assembly
installed.
Important: Do not use a damaged element.
Note: Cleaning of the used air-filter element is not
recommended due to the possibility of damage to the filter
media.
1. Clean the dirt ejection port located on the air-filter
cover.
2. Remove the rubber outlet valve from the cover, clean
the cavity, and replace the outlet valve.
29
Figure 29
3. Air-filter cover
4. Latch
(Figure 29).
(Figure 29).
Installing the Air Filter (page
Replacing the Air Filter (page
Installing the Air Filter
29).
29).