Checking The Transaxle Oil Level; Changing The Transaxle Oil - Toro Workman MD Operator's Manual

1. Jam nut
8. Rotate both tie rods to move the front of the tire
inward or outward.
9. Tighten the tie rod jam nuts when the adjustment is
correct.
10. Ensure that there is full travel of the steering wheel in
both directions.
Checking the Transaxle Oil
Level
Service Interval: Every 100 hours
Oil Type: SAE 10W30 (API service SJ or higher)
1. Move the machine to a level surface, shut off the
engine, set the parking brake, and remove the starter
key.
2. Remove the bolt from the level indicating hole
48).
Note: The transaxle fluid level should be at the
bottom of the level indicator hole.
1. Level indicator hole
3. If the transaxle oil is not level with the bottom of the
level indicating hole, fill the reservoir with the specified
oil; refer to Changing the Transaxle Oil (page
Figure 47
2. Tie rod
Figure 48

Changing the Transaxle Oil

Service Interval: Every 800 hours/Yearly (whichever comes
Oil Type: SAE 10W30 (API service SJ or higher)
Oil Capacity: 1.4 L (1.5 qt)
1. Position the vehicle on a level surface, set the parking
brake, rotate the On/Off switch to the Off position,
and remove the key.
2. Wipe the area around the fill and drain plugs clean with
a rag
1. Drain plug
3. Align a drain pan with a capacity of 2 L (2.1 qt) or more
under the drain plug.
4. Remove the fill plug by rotating it counterclockwise
(Figure
(Figure
Note: Retain the fill plug and gasket for installation
in step 8.
5. Remove the drain plug by rotating it counterclockwise
(Figure
Note: Retain the drain plug and gasket for installation
in step 6.
Note: Allow the oil to drain from the transaxle
completely.
6. Install and tighten the drain plug and gasket into the
drain-plug hole of the transmission
Note: Dispose of the used oil at a certified recycling
center.
7. Fill the reservoir
with approximately 1.4 L (1-1/2 qt) of the specified oil
or until the oil level in the transmission is even with the
40).
bottom of the threads.
40
first)
(Figure 49).
Figure 49
2. Fill plug
49).
49).
(Figure 50) through the fill-plug hole
(Figure
(Figure 49).
49).