Adding Rear Brake Fluid; Checking The Rear Brake Linings - KTM 2009 690 Rally Factory Replica Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Adding rear brake fluid

x
8.47
Warning
Danger of accidents Brake system failure.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Have the brake system checked in an authorized KTM workshop, and do not ride any further.
Warning
Skin irritations Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidents Reduced braking due to old brake fluid.
–
Have the front and rear brake fluid replaced according to the service plan in an authorized KTM workshop.
Warning
Environmental hazard Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!

Checking the rear brake linings

8.48
Warning
Danger of accidents Reduced braking due to worn brake linings.
–
Worn brake linings should be replaced immediately in an authorized KTM workshop.
–
Stand the vehicle upright.
–
Turn screw cap
–
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Mount the screw cap with the membrane.
Info
Clean up overflowed or spilt brake fluid immediately with water.
600061-10
–
Check the brake linings for minimum thickness
Minimum thickness
» If the minimum thickness is less than specified:
–
Change the rear brake linings.
600064-10
in the direction of the arrow and remove it with membrane

.

p. 96)
≥ 1 mm (≥ 0.04 in)

(
x
.

p. 50)
48
.
