Table of Contents
Advertisement
RIDING INSTRUCTIONS
Checks before putting into operation
6.1
Info
Make sure that the motorcycle is in a perfect technical condition before use.
Info
In the interests of riding safety, make a habit of making a general check before you ride.
–
Check the engine oil level. (
–
Check the chain tension. (
–
Check the chain dirt accumulation. (
–
Check the tire condition. (
–
Check the tire air pressure. (
–
Check the front brake fluid level. (
–
Check the rear brake fluid level. (
–
Check the front brake linings. (
–
Check the rear brake linings. (
–
Check brake system function.
–
Check the coolant level. (
–
Check that all operating elements are correctly adjusted and free to move.
–
Check that the electrical equipment is functioning properly.
Starting
6.2
Danger
Danger of poisoning Exhaust gases are poisonous and can result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in a closed
space without an effective exhaust extraction system.
Note
Engine failure High engine speeds in cold engines have a negative effect on the service life of the engine.
–
Always warm up the engine at low engine speeds.
Info
If the motorcycle is unwilling to start, the cause can be old fuel in the float chamber. The flammable elements of the fuel
evaporate after a long time of standing.
If the float chamber is filled with fresh fuel, the engine starts immediately.
Press the starter for a maximum of 5 seconds. Wait for a least 5 seconds until trying again.
Condition
Motorcycle standing still: ≥ 1 week
–
Empty the carburetor float chamber.
–
Remove the motorcycle from the stand.
–
Shift gear to neutral.
–
Flip the ignition switch down.
Condition
Engine cold
–
Pull the choke knob out slightly and turn it.
–
Press the electric starter button.
Info
Don't open the throttle.
p. 67)
p. 40)
p. 40)
p. 53)
p. 54)
p. 43)
p. 47)
p. 44)
p. 48)
p. 63)
23
Hide quick links:
Advertisement
Table of Contents
