Lowrance GlobalMap 5200C Operation Instructions Manual page 144

Calibrate is highlighted on the device configuration menu (left). Cali-
bration menu (right) with calibration instructions listed at the top.
3-Point Calibration
3-point calibration is designed for tanks that vary in shape from the top
to the bottom. You can begin calibration at any point in the 3-point
process, but we recommend starting calibration with an empty tank. In
a 3-point calibration, you will set three points, one each for empty, half
and full levels.
1. Press
MENU| MENU
2. Highlight
B
ration menu. A list of network devices will be at the top of the page. 3.
Select the EP-15 Fluid Level and press
4. Press ↓ to select
menu will appear.
5. Highlight
N
Make sure your tank is empty, then highlight
6.
.
ENT Select E
MPTY LEVEL
Select
7. C
ALIBRATE
Empty Level Calibration Completed. Press
Add half a tank of fuel, highlight
8.
and press
H
ALF LEVEL
Select
9. C
ALIBRATE
Half Level Calibration Completed. Press
10. Fill up the tank, then highlight
and press
F
ULL LEVEL
, use ↓ ↑ to select
and press
S
US ETUP
C
ALIBRATE
, press
P ENT
UM TS
and press ENT .
and press
ENT .
and press
ENT .
NMEA 2000
, which will open the Bus Configu-
ENT
.
ENT
and press
ENT
and select . Press
3
. The following message will appear:
ENT
ENTER
F L
LUID
. The following message will appear:
ENT
ENT
F L
LUID
138
and press
. The Device Calibration
.
ENT
F L
LUID EVEL
.
and press
EVEL
.
and press
EVEL
.
ENT
and press
. Select
ENT
. Select
ENT