Lowrance GlobalMap 5200C Operation Instructions Manual page 135

EP-10 Fuel Flow Configuration
To input Device Name:
1. Press
MENU| MENU
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the fuel flow you want to rename and press
Configuration menu will appear with the Device Name dialog box high-
lighted.
4. Press
ENTER
flow. Press
ENT
To select a Location:
1. Press
MENU| MENU
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the desired fuel flow and press
menu will appear.
4. Select
L
OCATION
with following options: Port, Center, Starboard and Unknown.
5. Highlight the desired location and press
will appear: Are you sure you wish to change this device's configuration?
6. Select
Y
ES
main display.
Advanced Options menu
The Fuel Flow sensor Advanced Options menu contains two categories:
Instance and Restore Defaults.
Instance
The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to re-
solve certain electronic probe conflicts. This is most likely to occur if the
network includes LMF-200 or LMF-400 digital gauges, which support
the display of fewer electronic probes than your GPS or sonar/GPS unit.
If you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service.
, use ↑ ↓ to select
and press
S
US ETUP
and use ↑ ↓, ← → to input the desired name for the fuel
. Press
EXIT
, use ↑ ↓ to select
and press
S
US ETUP
and press
and press
ENT
NMEA 2000
, which will open the Bus Configu-
ENT
repeatedly to get back to the main display.
NMEA 2000
, which will open the Bus Configu-
ENT
ENT
, which will open the Location menu
ENT
. Press
EXIT
129
and press
ENT
and press
. The Device Configuration
. The following message
ENT
repeatedly to get back to the
. The
ENT
. The Device
. The
ENT