Linking And Unlinking The Remote Keyless Entry Transmitter To Memory - Dodge Durango 2014 Owner's Manual

170 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
NOTE:
• Memory profiles can be set without the vehicle in
PARK, but the vehicle must be in PARK to recall a
memory profile.
• The Recall Memory with the "Memory To FOB" fea-
ture can be enabled through the Uconnect® system
screen. Refer to "Customer- Programmable Features —
Uconnect® Access 8.4 Settings " in "Understanding
Your Instrument Panel" for further information.
Linking And Unlinking The Remote Keyless Entry
Transmitter To Memory
Your RKE transmitters can be programmed to recall one
of two pre-programmed memory profiles by pressing the
UNLOCK button on the RKE transmitter.
NOTE: Before programming your RKE transmitters you
must select the "Memory To FOB" feature through the
Uconnect® system screen. Refer to "Customer- Program-
mable Features — Uconnect® Access 8.4 Settings " in
"Understanding Your Instrument Panel" for further in-
formation.
To program your RKE transmitters, perform the following:
1. Remove the Key Fob from the ignition (or change the
ignition to OFF, for vehicles equipped with Keyless
Enter-N-Go™).
2. Select desired memory profile (1) or (2).
NOTE: If a memory profile has not already been set, refer
to Programming The Memory Feature for instructions
on how to set a memory profile.
3. Once the profile has been recalled, press and release
the SET (S) button on the memory switch, then press
and release button (1) or (2) accordingly. "Memory