Turning The Set On/Off; First Installation Wizard - Loewe Xelos A 42 HD+ 100 Operating Instructions Manual

Initial installation

Turning the set on/off

Switching the TV set to standby mode
Activate the mains switch on the back/bottom of the set.
The display in the control panel on the front of the set
will be illuminated red, the set is now in standby mode.
Switching the TV on/off on the control unit
Press the on/off button in the middle for about 2 seconds
to switch the TV set on/off.
Display
Meaning of the display colour:
Red: Standby mode
Green: TV set is switched on
Orange: Radio mode, TV set receives EPG data or timer
recording active
Switching the set on with the remote control
Press the on/off button
or
numeric buttons (0–99)
or
TV button
or
OK button – station list is called
or
ASSIST button – Assist + menu is called.
Switching the set off with the remote control
Press the on/off button.
➠ Before switching off the set with the mains switch, we
recommend you to switch it to standby mode.
Switch on in Radio mode
Press R on the TV control unit.
or:
Press the RADIO button on the remote control
(radio mode, see page 34).
- 12
33156_024_Xelos_A32_42_GB_9_00_B12 12 33156_024_Xelos_A32_42_GB_9_00_B12 12

First installation wizard

Initial installation after switching on for the first time
This wizard starts automatically after the set is switched on for the first
time, however it can also be called later manually in the TV index, see
Repeat initial installation on page 16.
First installation wizard
Which language do you want to use for operation?
Initial installation
Language
Sprache D
Language GB
Langue F
Lingua I
Idioma E
Taal NL
Jazyk CZ
Γλώσσα GR
Język PL
Nyelv H
Proceed
OK
The first step with the wizard starts when selecting the
language for the user prompts. From this point on
follow the instructions on your TV set.
Brief explanation of button functions:
Press the ring (up, down, left, right) to move the cursor
and to select settings.
By pressing the OK button a setting is confirmed and you
will go to the next step.
With the yellow button you can select or remove the indi-
vidual items (see the example below).
When an element is selected, it is marked by a checkmark
.
Use this button to go back one step.
Exit the wizard with the END button (if available).
Initial installation
Connect antenna cable(s)
Antenna cable(s) for:
Antenna/cable (analogue)
DVB-T
DVB-C
DVB-S (cable 1)
DVB-S (cable 2)
Proceed
OK
An example of multiple selection using the yellow button.
Kieli FIN
Jezik SLO
OK
Jazyk SK
Lisan TR
Språk S
Sprog DK
Idioma P
Язык RUS
Språk N
to antenna socket(s):
ANT TV 
ANT TV 
ANT TV
ANT SAT 
ANT SAT2
Connect/disconnect
Back
continued on next page
03.07.2008 15:36:46 03.07.2008 15:36:46