Devices To The Hdmi (Dvi) Connections - Loewe Xelos A 42 HD+ 100 Operating Instructions Manual

Operating additional equipment
Devices to the HDMI ( DVI) connections
The HDMI connections (High Definition Multimedia
Interface) allow the transmission of digital video and
audio signals from a player, e.g. DVD player, DVD re-
corder, Blu-ray player, game console or Set-Top-Box via
a single cable.
The digital video and audio data are transmitted without data compression
digitally and therefore lose none of their quality.
Your TV set shows 24p films (see glossary on page 62) which are output
by a player connected via HDMI, e.g. Loewe BluTech Vision, automatically
in the original 24p format.
Film quality improvement (DMM) must be set to on (see page 21).
Digital video signals from a DVI player can be also be reproduced by the
HDMI connection using a DVI/HDMI adapter cable. The sound must be
piped in additionally.
HDMI and DVI both use the same copy protection method HDCP.
Connecting the device
➠ It is not necessary to register HDMI devices with the
connection wizard.
Switch off all equipment before connecting.
Connect the device with an HDMI cable (type A, 19-wire)
to the HDMI1/DVI or HDMI2/DVI socket of the TV set.
Connection
example of a
Blu-ray player
If a DVI/HDMI adapter cable is used, the corresponding
sound can be piped through the AUDIO IN1 (analogue)
or AUDIO DIGITAL IN (digital) socket on the TV set (see
also page 49).
- 44
33156_024_Xelos_A32_42_GB_9_00_B44 44 33156_024_Xelos_A32_42_GB_9_00_B44 44
Playback from the device
Digital Link HD in CEC-capable devices
With Digital Link HD accessory equipment with CEC support (e.g. Loewe
BluTech Vision) is controlled by the TV set. A concealed installation of the
accessory equipment is also possible.
Operation of equipment with Digital Link HD
As long as a HDMI programme slot is selected, all remote control com-
mands which can be processed by the device connected to the respective
socket are passed on to it. The device can therefore be installed concealed
and still be controlled.
TV set
➠ Volume setting, sound off/on, listen mode and selection of picture
format always act on the operation of the TV set.
HDMI2
Blu-ray player
Remote TV switch on via Digital Link HD
In the TV menu under Connections → Miscellaneous → Remote TV switch
on via Digital Link HD, you can select whether the TV set is to switch on
automatically from standby mode when a disc is played or a screen menu
displayed on connected Digital Link HD-capable HDMI equipment.
Call AV selection.
AV selection
COMP. IN
HDMI2/DVI
HDMI1/DVI
OK
PC IN
AVS
DVD-REC
DVD
VIDEO
Switch to ...
OK
Select HDMI1/DVI or HDMI2/DVI socket,
OK switch over.
Start playback on the connected HDMI device. The best
possible format for the picture is detected and set auto-
matically.
On/off button:
short: Switch off TV set to the standby mode.
long: Switch off TV set and connected Digital Link HD-
capable equipment to the standby mode (system
standby).
TV button:
short: Switch back to the last viewed TV station.
long: Switch Digital Link HD on/off temporarily.
END
03.07.2008 15:39:02 03.07.2008 15:39:02