Managing Stations; Tv Stations - Loewe 46, 40 Operating Instructions Manual

Managing stations

TV stations

Various options for managing stations are available via the TV menu. For
example the description for TV stations. For radio stations the same applies,
except that the radio menu is called in radio mode (see also page 4).
➠ Station management is not possible if a programmed timer record-
ing is still pending.
Search/update stations – Search wizard
In the search/update with the search wizard, new stations are searched
for which are not yet stored.
➠ You have to repeat the initial installation (see page 11)
and automatically search for new ones if you want to
delete all the existing stations and automatically search
for new ones.
Call TV menu.
3 4 S elect Settings,
6 go to the menu line below.
3 4 S elect Stations,
6 go to the menu line below.
3 4 S elect Search wizard,
6 go to the menu line below.
In the upper info text the current search settings will now
be displayed:
Search wizard
Your TV carries out the update of the station range (search for new stations;
delete stations no longer broadcast) with the following settings:
Location of TV set
Signal source
TV/colour standard
TV menu
Settings
Stations
Search wizard
Change search settings
If you want to change these search settings:
3 4 S elect Change search settings,
OK wizard prompts search settings.
If you agree with these settings:
3 4 S elect Start search/update,
OK start search.
Red button: Abort current search/update.
- 
Germany
Antenna/cable (analogue)
PAL-BG
END
Start search/update
OK
Explanations of some search settings:
Set location Select the country for country-specific defaults and
station sorting.
Signal source Select antenna, cable, or satellite here, depending on
where you want to search for new stations.
At this point you can also call a configuration of the
DVB-T and DVB-S antennae via the yellow button (see
page 1).
Antenna/cable: With selection of set location the conventional TV
TV/colour
standard/colour standard is the default. This should only
standard be changed if stations with other standards are to be
searched.
DVB-T If you want to run the station search independently of
Search method the channel grid, select frequency search for the search
method.
DVB-C With the selection of set location the conventional set-
Settings tings will be preset. Only change this if you know other
symbol rates and modulation types or if you have to
specify the network ID for your cable network (informa-
tion available from your cable network provider).
If you want to run the station search independently of
the channel grid, select frequency search for the search
method.
DVB-S The symbol rate is specified by the satellite provider and
Symbol rate normally does not need to be changed.
Search/update stations – Search ended
After the station search has ended, the number of new
found stations is displayed.
OK to continue.
If new stations are found, these are displayed with the
appropriate station number.
Search wizard
Automatic TV station search and sorting finished.
Search for/update station
New found stations
30 TELE 5
31 N 24
32 QVC
33 E26
Proceed
OK
OK to continue.
END: to exit search wizard.
OK