10.1.10 Replacement Of PC Door (Manufactured After May 2007)
• Disconnect the refrigerator from the power supply.
• Remove the top hinge cover to expose the wiring and water tubing.
• Disconnect the edge connector.
•
Remove the left hand collet-locking clip from the John Guest fitting (refer to photo below).
• Once the clip has been removed, push the collar in to remove the water tube.
• Remove the top hinge cover and hinge.
• Remove the water tube and wiring from the guide.
• Remove the door.
• Remove the door dispensing pad, wiring and water tube from the old door and refit all
components to the new door.
• Reassemble in reverse order.
10.1.11 Replacement Of PC Door (Manufactured Before May 2007)
(Without John Guest fitting under top hinge cover).
• Turn the power off to the refrigerator.
• Turn off the water (if connected).
• Remove the hinge cover.
• Disconnect the RAST connector.
• Remove the top hinge.
• Remove the LCD display and disconnect the bottom hose off the flow meter.
Collet-locking clips in
position. Remove left hand
clip to remove the door.
37
517804E