Water Valve Replacement; Display Module Replacement - Fisher & Paykel E522BLXU Service Manual

517804E
10.1.5

Water Valve Replacement

• Ensure the water is turned off at supply tape.
• Disconnect the refrigerator from the power supply.
• Pull the product away from the wall to access the rear of the product.
• To remove the water tube from the water valve, push the inner part of the clip inwards and
hold down while pulling the tube from the valve. Drain the water (approximately 1½ litres)
into a container.
• Remove the RAST connector from the water valve.
• Remove two screws holding the valve to the back wall of the unit compartment.
• Refit in reverse order.
10.1.6

Display Module Replacement

The display module is located on the front of the door.
To remove the module:
Step 1
• Disconnect the refrigerator from the power
supply.
• Push the tabs upwards and gently pull the
panel forward once the tabs release.
• A small screwdriver or key may need to be
used to dislodge the tabs from the housing.
Step 2
• Two locating pins on the base of the front
panel hold the housing at the bottom.
Note: The housing cannot be removed, as
wiring looms prevent the housing being
removed.
Step 3
• Disconnect the RAST connectors from the
module.
• Pull the two bottom tabs forward.
• Remove the module.
Locating pins
34