Fisher & Paykel E522BLXU Service Manual page 19

Fault Code 25
Reason:
Primary Action:
Secondary Action:
Fault Code 26
Reason:
Primary Action:
Secondary Action:
Fault Code 27
Reason:
Primary Action:
Secondary Action:
Fault Code 28
Reason:
Primary Action:
Secondary Action:
Fault Code 29
Reason:
Primary Action:
Secondary Action:
Fault Code 32
Reason:
Primary Action:
Fault Code 33
Reason:
Primary Action:
Fault Code 34
Reason:
Primary Action:
The resistance of the ice tray sensor is outside normal range.(< 660
Ohms). Sensor hot.
Check the connections of the sensor at the module. Check the resistance
of the sensor.
Replace the sensor.
Icemaker motor timed out
The icemaker gearbox is not returning to the start position and ends signal
to the controller.
Check the gearbox, and if faulty, replace.
Icemaker motor current high.
Check motor for obstruction. Check wiring at both the icemaker gearbox
and the power module.
Clear obstruction.
resistance. If not within limits, replace motor.
Icemaker solenoid current high.
Check the connections to the solenoid.
solenoid.
Correct loose connections. Replace the solenoid if faulty.
Icemaker solenoid current low.
Check the connection to the solenoid.
solenoid.
Correct loose connections at the module or the water valve. Replace the
solenoids if open circuit.
Solenoid Driver 1 has failed. If this happens, the water dispenser will still
be operating, however as Solenoid Driver 1 has failed, the product has
reverted to Solenoid Driver 2 to dispense water. Fault code 32 will be
displayed to make the customer aware of the fault.
Check the solenoid resistance. If not within limits, replace the solenoid. If
OK, replace the display module if the problem still present.
Solenoid Driver 2 has failed.
Solenoid Driver 2; however Solenoid Driver 1 may still be operational and
the water dispenser is still working.
Check the solenoid resistance. If not within limits, replace the solenoid. If
OK, replace the display module.
Both Solenoid Drivers 1 and 2 have been detected to have a fault.
Check the solenoid resistance. If not within limits, replace the solenoid. If
OK, replace the display module.
Test motor operations.
The module has detected a fault with
19
Check the gearbox motor
Check the resistance of the
Check the resistance of the
517804