Stoplamps; License Plate Lamp - Buick Enclave 2016 Manual

Taillamps, Turn Signal,
and Stoplamps
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
0 33.
2. Using a small flat bladed tool,
remove the screw covers by
prying them from the bottom.
3. Remove the two hex screws
holding the taillamp assembly
in place.
4. Pull out the taillamp assembly.
5. Turn the bulb socket
counterclockwise and pull it
straight out to remove it.
6. Replace the bulb.
7. Reverse Steps 3 5 to reinstall
the taillamp assembly.
When reinstalling the taillamp
assembly, the pin on the
taillamp assembly must line up
and be inserted correctly into
the opening.
8. Replace the screw covers.

License Plate Lamp

To replace one of these bulbs:
1. Remove the two push pins
holding each of the license
plate lamps to the liftgate trim
by unscrewing them.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care
2. Turn and pull the license plate
lamp forward through the
liftgate trim opening.
3. Turn the bulb socket
counterclockwise and pull the
bulb straight out of the socket.
4. Install the new bulb.
5. Reverse Steps 1 3 to reinstall
the license plate lamp.
255