Clock - Buick Enclave 2016 Manual

104 Instruments and Controls
To calibrate the compass, use the
following procedure:
Compass Calibration Procedure
1. Before calibrating the compass,
make sure the compass zone
is set to the variance zone in
which the vehicle is located.
See Compass Variance (Zone)
Procedure earlier in this
section.
Do not operate any switches
such as window, sunroof,
climate controls, seats, etc.
during the calibration
procedure.
2. Press the vehicle information
button until PRESS
CALIBRATE COMPASS
displays.
3. Press the set/reset button to
start the compass calibration.
4. The DIC will display
CALIBRATING: DRIVE IN
CIRCLES. Drive the vehicle in
tight circles at less than 8 km/h
(5 mph) to complete the
calibration. The DIC will display
CALIBRATION COMPLETE for
a few seconds when the
calibration is complete. The
DIC display will then return to
the previous menu.

Clock

Setting the Digital Clock
Press Settings on the Home Page,
then press the Set Time or Set Date
settings screen button to display the
different options for setting the time
and date.
Set Time:
Press the up or down arrows to
change the Hours, Minutes, AM,
PM, or the 24 hour setting on the
TO
clock.
Press and hold to quickly
increase or decrease the time
settings.
Press OK to save the
adjustments.
Press the Back or Cancel screen
button to cancel the
adjustments.
I n f o r ma t i o n P r o v i d e d b y :
Set Date:
Press the up or down arrows to
increase or decrease the Month,
Day, and Year settings.
Press and hold to quickly
increase or decrease the date
settings.
Press OK to save the
adjustments.
Press the Back or Cancel screen
button to cancel the
adjustments.
Setting the Analog Clock
The analog clock is on the
instrument panel above the radio.
The clock is not connected with any
other vehicle system and runs by
itself. To adjust the time:
1. Press and hold the button
directly above the clock to
quickly advance the time.
2. Press and release the
button to increase the time by
one-minute intervals.