Buick Enclave 2016 Manual page 291

290 Vehicle Care
2. Remove the small center cap
by tapping the back of the cap
with the extension of the shaft,
if the vehicle has aluminum
wheels.
3. Put the flat tire in the rear
storage area with the valve
stem pointing toward the rear
of the vehicle.
4. Pull the cable (1) through the
door striker (5), the center of
the wheel (4), and the plastic
spare tire heat shield (3), as
shown.
5. Hook the cable onto the
outside portion of the liftgate
hinges (2).
6. Hook the other end of the cable
onto the outside portion of the
liftgate hinge on the other side
of the vehicle.
7. Pull on the cable to make sure
it is secure.
8. Make sure the metal tube is
centered at the striker. Push
the tube toward the front of the
vehicle.
9. Close the liftgate and make
I n f o r ma t i o n P r o v i d e d b y :
sure it is latched properly.
Storing the Tools
1. Tool Bag
2. Wing Bolt
3. Jack
Put back all tools as they were
stored in the jack storage
compartment and put the
compartment cover back on.
1. Ensure that the bottom of the
jack is facing toward you.
2. Replace the tool bag (1).
3. Turn the jack (3) on its side and
place down on the holding
bracket.