Buick Enclave 2016 Manual page 56

row seat, or lift the seatback
and push it into place from
inside the vehicle.
Warning
If either seatback is not locked, it
could move forward in a sudden
stop or crash. That could cause
injury to the person sitting there.
Always push and pull on the
seatbacks to be sure they are
locked.
2. Push and pull on the seatback
to make sure it is locked in
place.
Warning
A safety belt that is improperly
routed, not properly attached,
or twisted will not provide the
protection needed in a crash. The
person wearing the belt could be
seriously injured. After raising the
rear seatback, always check to be
(Continued)
Warning (Continued)
sure that the safety belts are
properly routed and attached, and
are not twisted.
3. Reconnect the center safety
belt mini-latch to the
mini-buckle. Do not let it twist.
4. Pull on the safety belt to be
sure the mini-latch is secure.
Removing the Third Row Seats
To remove a third row seat:
1. Remove the cargo
management system, if it is
installed. See Cargo
Management System 0 96.
2. Remove anything on or under
the seat.
Caution
Folding a rear seat with the safety
belts still fastened may cause
damage to the seat or the safety
I n f o r ma t i o n P r o v i d e d b y :
(Continued)
Seats and Restraints
Caution (Continued)
belts. Always unbuckle the safety
belts and return them to their
normal stowed position before
folding a rear seat.
3. Fold the seatback down. See
Folding the Seatback earlier
in this section.
4. Remove the rear bolts on the
floor on each side of the seat.
5. Remove the seat by tilting it
slightly upward, and then
pulling it out of the rear of the
vehicle in one motion.
6. Replace the bolts in the floor
holes for storage.
Installing the Third Row Seats
To reinstall a third row seat:
1. Before installing the seat, the
seatback must be folded
forward. See Folding the
Seatback earlier in this
section.
55