Driver Assistance Systems; Rear Vision Camera (Rvc) - Buick Enclave 2016 Manual

212 Driving and Operating
Ending Cruise Control
There are four ways to end cruise
control:
Step lightly on the brake pedal.
Press .
Shift the transmission to
N (Neutral).
To turn off the cruise control,
press .
Erasing Speed Memory
The cruise control set speed is
erased from memory if
pressed or the ignition is turned off.
Driver Assistance
Systems
Rear Vision
Camera (RVC)
The vehicle may have an RVC
system. Read this entire section
before using it.
The camera(s) do not display
children, pedestrians, bicyclists,
is
crossing traffic, animals, or any
other object outside of the
cameras field of view, below the
bumper, or under the vehicle.
Shown distances may be different
from actual distances. Do not
drive or park the vehicle using
only these camera(s). Always
check behind and around the
vehicle before driving. Failure to
use proper care may result in
injury, death, or vehicle damage.
Warning
I n f o r ma t i o n P r o v i d e d b y :
The RVC system is designed to
help the driver when backing up by
displaying a view of the area behind
the vehicle. When the driver shifts
the vehicle into R (Reverse), the
video image automatically appears
on the infotainment screen. Once
the driver shifts out of R (Reverse),
the screen will go back to the last
screen that had been displayed,
after a delay.
The RVC display remains on after
shifting out of R (Reverse) for
approximately 10 seconds. Return to
the previous screen sooner by
performing one of the following:
Press a hard key on the
infotainment system.
Shift into P (Park).
Reach a vehicle speed of
8 km/h (5 mph).
Symbols and Guidelines
The RVC system may have a
feature that lets the driver view
caution symbols on the RVC screen
while using the RVC. The Rear