Headlamps, Front Turn Signal And Parking Lamps; Fog Lamps; Taillamps, Turn Signal; Stoplamps, And Back-Up - Buick 2016 Regal Owner's Manual

Headlamps, Front Turn
Signal and Parking

Lamps

Low-Beam Headlamp/Daytime
Running Lamp (Base)
1. For the driver side bulb,
remove the windshield washer
bottle filler neck by firmly
pulling it straight up and out of
the bottle.
2. Remove the cap from the back
of the headlamp assembly.
3. Disconnect the electrical
connector.
4. Remove the bulb socket from
the headlamp assembly.
5. Reverse steps 1 4 to install.
High/Low-Beam Headlamps
(Uplevel)
The high/low-beam headlamps on
the uplevel headlamp system are
High Intensity Discharge (HID) and
should be replaced by your dealer.
Front Turn Signal and
Sidemarker Lamps (Base and
Uplevel)
1. Remove the outside cap from
the uplevel headlamp
assembly.
2. Remove the bulb socket from
the headlamp assembly.
3. Remove the bulb from the
socket.
4. Reverse Steps 1 3 to install.

Fog Lamps

To replace the fog lamp bulb:
1. Locate the bulb assembly
under the front fascia.
2. Disconnect the electrical
connector from the bulb
assembly.
3. Remove the bulb by turning it
counterclockwise and pulling it
straight out of the assembly.
Vehicle Care
4. Install the new bulb by turning
it clockwise into the assembly.
5. Reconnect the electrical
connector to the bulb
assembly.

Taillamps, Turn Signal,

Stoplamps, and Back-Up

Lamps
To replace any one of these bulbs:
1. Open the trunk. See Trunk
Release 0 10.
2. Remove the trunk trim panel
push pin.
3. Pull the trunk trim panel back
to gain access to the taillamp
assembly.
4. Remove the three nuts that
secure the taillamp assembly.
5. Remove the taillamp assembly
and disconnect the wiring
harness connector.
247