Table of Contents
Advertisement
Item
PERFECT FIT
(continued)
AUTO ECO MODE
ECO MODE
(continued on next page)
• While the distortion is adjusted with the PERFECT FIT function,
keystone adjustment feature is unavailable. To correct the keystone
distortion, reset the adjustment of all the corners and sides.
• The adjustable range of this correction will vary among inputs. For
some input, this function may not work well.
• One adjustment position common to the top and bottom sides can
be set. Also, another adjustment position common to the left and
right sides can be set.
• The distortion of the top and bottom sides can be adjusted only in
the same direction, pincushion or barrel. The adjustment for the left
and right sides is carried out in the same manner.
• This function will be unavailable when the TRANSITION
DETECTOR is on (84).
Using the ▲/▼ buttons turns on/off the AUTO ECO MODE.
ON ó OFF
• When ON is selected, the projector will always be set to Eco mode
at start-up regardless of the ECO MODE (47) setting. An OSD
message "AUTO ECO MODE" will be displayed for tens of seconds
when the projector starts with this function activated.
Using the ◄/► buttons switches the ECO MODE.
NORMAL ó ECO ó INTELLIGENT ECO ó SAVER
• When the ECO is selected, acoustic noise and screen brightness
are reduced.
• When INTELLIGENT ECO is selected, the brightness of the
lamp changes according to the level of the input signal. The lamp
becomes brighter when the input signal level is high and darker
when the level is low. If dark images are projected continuously, the
brightness of the lamp may increase to maintain its performance.
• When SAVER is selected, you can select the time within 1 to 30
min. for SAVER MODE using the ► button. If the image signal level
doesn't change more than the period set, the lamp brightness is
reduced and electric power consumption decreased. If the image
signal level changes or any buttons are operated, the lamp will
brighten again. If dark images are projected continuously, the
brightness of the lamp may increase to maintain its performance.
• When AUTO ECO MODE (above) is set to ON, the projector will
always be set to Eco mode at start-up regardless this setting.
• When the ambient temperature is around 35 to 40°C, the
brightness of lamp is reduced automatically.
Description
SETUP menu
47
Advertisement
Table of Contents
