Table of Contents
Advertisement
OPTION menu
Item
SERVICE
(continued)
(continued on next page)
66
RESPONSE LIMIT TIME
Select the time period to wait for receiving
response data from other device communicating by
the NETWORK BRIDGE and the HALF-DUPLEX
through the CONTROL port.
OFF: Select this mode if it is not required to check
COMMUNICATION
(continued)
1s /2s /3s: Select the time period to keep the
• This menu is available only when the NETWORK
BRIDGE is selected for the COMMUNICATION
TYPE and the HALF-DUPLEX is selected for the
TRANSMISSION METHOD (65).
• OFF is selected as the default setting.
The setttings of the projector can be coppied via USB
memory.
SAVE: Saves each settings of the projector to USB
CLONING
LOAD: Loads each settings of the projector from
Description
OFF ó 1s ó 2s ó 3s
the responses from the device that the projector
sends data to. In this mode, the projector can
send out data from the computer continuously.
projector waiting for response from the device
that the projector sends data to. While waiting the
response, the projector does not send out any
data from the CONTROL port.
memory.
USB memory. Message will be displayed
after loading, and power will turn off after five
min. or by pressing ► button. (A message is
displayed for a few seconds if loading fails.)
Advertisement
Table of Contents
