SiENBE04-808_A
1.6
Removal of PCB
Procedure
Step
1. Remove the shield plate.
1
The figure shows the
appearance of the
electrical box.
2
Unfasten the hooks at
the upper 2 positions of
the shield plate.
3
Unfasten the hook at
the side of the shield
plate.
Lift up the shield plate
4
to unfasten the lower
hooks and remove it.
2. Remove the terminal
board.
1
Remove the screw to
remove the terminal
board.
Removal Procedure
Warning
Be sure to wait 10 minutes or more after turning off all power supplies
before disassembling work.
Procedure
Control PCB
Signal receiver PCB
Hook
Terminal board
Preparation
Remove the electrical box
Shield plate
according to the "Removal
of Electrical Box".
INTELLIGENT EYE
sensor PCB
(R8083)
Hook
(R8085)
Shield plate
Hook (side)
Hook (lower)
(R10619)
(R10315)
Indoor Unit
Points
168