Setting The Current Day And Time; Setting The Vveekday Program Times And Heating Temperatures - Robertshaw 300-224 Installation And Programming Instructions

SETTING THE CURRENT DAY AND TIME

Before you set the current day and time, set the thermostat into the proper time mode by press-
ing the Daylight Saving Time (DST} button. If the thermostat has been installed during Daylight
y
Sa ing Time, press and release the DST button until the clock symbol in the lower right corner
of the display appears. If the thermostat has been installed during Standard Time, press the DST
button until the clack symbol disappears.
1. Press the CLOCK button: The display will flash a day of the week.
2. Press the s or t buttons until the current day shows.
3. Press the CLOCK button again. The display will flash the hour.
(Note the AM/PM indicator).
4. Press the s or t buttons until the current hour shows.
1
5. Press the CLOCK button again. The display will flash the minutes.
/ \ 6. Press the s or t buttons until the current minutes show.
4-11
12 7. Press the CLOCK button and the current day and time are set.
••_1 0
Note: If a button is not pushed in 15 seconds, the thermostat will automati-
cally return to normal operation.
n
E
With your specific program determined, you are ready to begin programming. Now
you will enter the times and temperatures for the weekday program period. Refer to
your schedule planner for the appropriate times and heating temperature.
1. Press the MODE button until HEAT is displayed
2. Press the PROGRAM button.
Tu Wen, N
the morning symbol. The starting time will flash.
3. Press the s or t buttons to adjust the desired morning start time.
(Note AM/PM indicators.)
4. Press the PROGRAM button. The display will flash the minutes.
rga Tay
r E
aspa p
l iji:E
MO TU WE TH FR
32
RAIIVI
TIMES
will be displayed along with