Cover Lock; Replacing The Thermostat On The Subbase - Robertshaw 300-224 Installation And Programming Instructions

Deluxe programmable thermostats

Hide thumbs Also See for 300-224:

Table of Contents

COVER LOCK

You also may lock the cover down to prevent unauthorized access to the thermostat by adding

the dear plastic lock (included in the installation bag). To install, remove the thermostat from the

subbase and place the dear plastic lock in the subbase as shown below. Replace the thermo-

stat and close the cover. The cover now is locked. To open, simply use a screwdriver to push

the lock back allowing the cover to open. To remove the lock, open the cover, remove the ther-

mostat from the subbase, then remove the lock.

1. Position the thermostat on the hinged tabs located at the top of the subbase.

2. Gently s+hing the thermostat dawn and press on the bottom center edge until it snaps in place.

Table of Contents

Show Quick Links

Table of Contents

300-226 300-225 300-227 300-229 300-230