Programming 7 Day Models; Setting The Current Day And Time; Setting Your Program Temperatures - Robertshaw 300-224 Installation And Programming Instructions

SETTING THE CURRENT DAY AND TIME

1. Press the CLOCK Button.* The display will flash a day of the week.
2. Press the
3. Press the CLOCK button again. The display will flash the hour. (Note the
AM/PM indicator.)
4. Press the
Mo
5. Press the CLOCK button again. The display will flash the minutes.
6. Press the
7. Press the CLOCK button and the current day and time are now set.
* Note: If a button is not pushed in 15 seconds, the thermostat will automatically
return to normal operation.

SETTING YOUR PROGRAM TEMPERATURES

With your specific program determined, you are ready to begin programming. You now will enter
the individual program period temperatures for the heating program.
1. Press the MODE button until HEAT is displayed.
2. Press the SET TEMP button.* The first program period (Morning) will be displayed.
3. Press the
for heating.
4. Repeat Steps 2 and 3 for the Day, Evening and Night program periods. Remember, if
your thermostat was set for two program periods, you will only have to repeat Steps
2 and 3 for the Night program period.
5. Press the MODE button until COOL is displayed. You now will enter the individual
program period temperatures for the cooling program.
6. Repeat Steps 2, 3 and 4 for the cooling temperatures.
7. Press the MODE button until your desired mode of operation appears:
HEAT-AUTO-OFF-COOL.
8. Press the RESUME button to return to normal operation.
Note: If a button is not pushed in 15 seconds, the thermostat will automatically return to normal
*
operation. You may go back into the programming portion simply by repeatedly pressing the
SET TEMP button until you get back to where you left off.
or buttons until the current day shows.
or buttons until the current hour shows.
or buttons until the current minutes show.
or
buttons to adjust that program period's temperature
26