Alcatel-Lucent 7210 Installation Manual page 59

Enter disable since we do not want the backup link.
Press Enter.
New Settings
------------
primary-image
primary-config
#uplinkA Port Settings:
uplinkA-port
uplinkA-address
uplinkA-vlan
uplinkA-route
#System Settings:
wait
persist
console-speed
Do you want to overwrite cf1:/bof.cfg with the new settings? (yes/no):
Type yes and press Enter.
The 7210 SAS-M should boot now.
Primary image location: ftp://*:*@10.10.170.22/./images/both.tim
Initializing uplinkA port using IP addr 10.135.4.172.
Loading image ftp://*:*@10.10.170.22/./images/both.tim
Version B-1.1.private, Wed Jul 15 17:18:37 IST 2009 by builder in /builder/ws/1.1B1/
main
text:(17446113-->76798004) + data:(2100172-->10874132)
Executing TiMOS image at 0x100000
...
After the 7210 SAS-M boots up, you should see the following prompt:
All rights reserved. All use subject to applicable license agreements.
Built on Wed Jul 15 17:18:37 IST 2009 by builder in /builder/ws/1.1B1/sultan
Login:
The default username and password are admin. Use it to log into the 7210 SAS-M.
Note:
and is running normally. It is highly recommended that you change the default admin password to
prevent unauthorized access to the node.
7210 SAS-M Installation Guide
ftp://*:*@10.10.170.22/./images/both.tim
none
1/1/24
10.135.4.172/24
0
10.10.170.0/24 next-hop 10.135.4.1
3
off
115200
The status LED will be Green when the device has successfully completed the boot process
Configuring the 7210 SAS-M
Page 59