THOMSON ST780 WL Cli Reference Manual page 606

protocol
outside_port
inside_port
mode
580
The IP protocol to be used as filter for inbound/outbound traffic.
The NAT map only applies if the protocol of the IP packet matches
the map protocol.
Select an IP protocol (see " Supported IP Protocols" on page
or, alternatively, type the protocol number.
The default is 0 (meaning any protocol).
The outside port number or range (only for maps of type napt).
>
For a NAPT map:
Represents the range of TCP/UDP ports to be used as dynamic
port range during the NAPT process.
>
For a port-shifting map:
Represents the source port(s) to be translated (shifted) into
inside_port.
Allowed values are:
>
TCP/UDP port range [P-Q] (with Q > P)
>
TCP/UDP port number (only for port-shifting maps).
The inside port number or range (only for maps of type napt).
If this parameter is specified for a map of type napt, then this map
is a port-shifting map.
Represents the target TCP/UDP ports to which the traffic has to be
shifted.
Allowed values are:
>
TCP/UDP port range [P-Q] (with Q > P)
>
TCP/UDP port number (only for port-shifting maps).
Note The size of inside_port
outside_port.
The mode to create the portmap.
Choose between:
>
auto
>
inbound
>
outbound.
The standard is auto.
must be identical to the size of
NAT Commands
OPTIONAL
862)
OPTIONAL
for NAPT
map.
REQUIRED
for port-
shifting map.
REQUIRED
for port-
shifting map
OPTIONAL
E-DOC-CTC-20061027-0012 v2.0